Senin, 07 Maret 2016

Dinghy Boat Plans


Today I overturned my bottom after gluing it last night. I was all very nice and neat and did my best and I was welcomed to see the fair bottom of my speed-demon boat with THIS:


HELLO DRAG. A giant glue mess that I will have to sand smooth. Which, if I estimate correctly, will take forever and a half. I shoulda woulda coulda put packaging tape around the seam, but my side panel job came out so neat (probably because I didnt put glue between the panels) that I didnt think I would see this. Also, note the glaring holes from my finishing nails that I used to pin the buttstraps in place. SOB, I went right through the ply. This is very embarrasing, I havent gone through the ply anywhere where I didnt want to, this is the first time, and I have no idea how I did it. Again, I didnt do it on the side panels, so why now?

In other news, I planed down the new shims that will fill the gap between the bottom and the BHs, and cut/chiselled some limber holes. They look nice and neat from this angle because the ply is on the other side, which is all chipped up. I shoulda woulda coulda dammit scored the ply to get nice smooth cuts first, before going after it with my chisel.


Notice the stringy thing coming out of the limber hole... thats some fabric coming out from IN BETWEEN the layers of the ply! OOOooooooooh, mystery!

You may also notice the cloudy color, that because Ive sanded the layer of epoxy there in preparation for bottom being glued on. Ive decided to put in mini fillets along the BHs and the bottom for practice and to re-enforce the double seam, one between the bottom and the spacer, and the on between the spacer and the bottom of the BH frame.

Do you find information about Dinghy Boat Plans are you looking for? If not, below may help you find more information about the Dinghy Boat Plans. Thank you for visiting, have a great day.

Related Posts by Categories

0 komentar:

Posting Komentar